WORKPLACE ELECTRICAL SAFETY REMINDERS
The following list of safety reminders is a brief compilation of generally accepted practices and should be adapted or modified to address the unique aspects of your working environment, your company policies, and local and/or state and Federal codes. The intent of this list is to stimulate your thinking on what are the important electrical safety considerations for the people in your workplace.
ELECTRICAL SAFETY PRINCIPLES
When planning and performing work on electrical systems and equipment, keep these principles in mind:
WORKING ON OR NEAR ENERGIZED EQUIPMENT
CORD POWERED EQUIPMENT AND TOOLS, CORDS AND TEMPORARY WIRING
EQUIPMENT AND TOOL GROUNDING
OTHER CONSIDERATIONS
ELECTRICAL SAFETY PRINCIPLES
When planning and performing work on electrical systems and equipment, keep these principles in mind:
- Plan every job.
- Think about what could go wrong.
- Use the right tools for the job.
- Use procedures, drawings and other documents as tools to do the job.
- Isolate the equipment from energy sources.
- Identify the electric shock and arc flash, as well as other hazards that may be present.
- Minimize the hazard by guarding or establishing approach limitations.
- Test every circuit and every conductor, every time before you touch.
- Use personal protective equipment (PPE) as a last line of defense in case something goes wrong.
- Be sure you are properly trained and qualified for the job.
WORKING ON OR NEAR ENERGIZED EQUIPMENT
- Treat de-energized electrical equipment and conductors as energized until lockout/tagout, test and ground (where appropriate) procedures are implemented.
- Work on electrical equipment and conductors only when de-energized, unless procedures and safeguards (PPE, guarding and approach distances) have been established to ensure zero exposure for the worker and other people in the area.
- Lockout/tagout and ground (where appropriate) before working on equipment.
- Wear protective clothing and equipment, and use insulated tools in areas where there are possible electrical hazards.
- De-energize and visibly guard (where possible) whenever contact with un-insulated overhead power lines is possible.
- Check and double check the safety regulations when a ladder or parts of any vehicle or mechanical equipment structure will be elevated near energized overhead power lines.
- Call your local electric utility for assistance. People standing on the ground may be particularly vulnerable to possible injury.
CORD POWERED EQUIPMENT AND TOOLS, CORDS AND TEMPORARY WIRING
- Protect flexible cords and cables from physical damage.
- Keep slack in flexible cords to prevent tension on electrical terminals.
- Check cords for cut, broken, or cracked insulation.
- Make sure the insulating qualities of a splice are equal to or greater than the original cord.
- Extension cords are for temporary use. Install permanent wiring when use is no longer temporary.
EQUIPMENT AND TOOL GROUNDING
- Verify that all three-wire tools and equipment are grounded.
- Water, electrical equipment, and power cords do not mix! Use GFCI protection in wet or damp environments.
- Ground exposed parts of fixed equipment that could become energized.
- Use non-conductive tools whenever possible.
- Always double check the operation of your voltage testers by testing a live circuit.
OTHER CONSIDERATIONS
- Verify location of all buried or embedded electrical circuits before digging or cutting.
- Determine the reason that a fuse operated or circuit breaker tripped before replacing or resetting.
- Know where your over-current devices are (i.e. circuit breakers and fuses) so they can be easily and quickly reached in case of emergency.
- When replacing lamps and bulbs, verify replacement matches fixture requirements.
- Adapt this list of reminders to fit your working environment!
- Establish a written electrical safety program for implementing the above.